Checklist

• Read and understand all the documentation
• Decide on the tools to use, See Docks for a calculation of how many will fit
• Decide on dock types, Modular Dock or other
• Decide if you are going top mount, or use a cross bar, 2040 or Door Buffer or MiniBFI
• Decide on a Tophat
• Decide on umbilical management WIP
• Visit the BOM to make sure you have ordered everything you need for the convertion
• Visit our Printing guide and start printing
• At this point please inspect your prints, take extra note that your hexes are very uniform, if the tops are flat you will have alignment issues, it doesn't take much for things to start off wrong here.
• Assemble the shuttle and backplates
• Install software
• Configure software
• Calibrate Z Offsets
• Calibrate Dock Parking
• Calibrate X/Y Offsets
• Registrer for a serial
• Visit our sponsor page